Molded Rubber
Molded Rubber
Molded RubberMolded RubberMolded Rubber - HomeMolded Rubber GoodsColumbia Engineered Rubber - ContactsMolded Rubber ManufacturerMolded Rubber Seal Design
Molded Rubber
Orings & Seals
Rubber Bellows and Convoluted Boots
Vibration Isolators and Mounts
Formed Rubber Hose
Molded Rubber Materials
custom molded rubber
o-rings and rubber seals
rubber bellows
vibration isolators & mounts
formed rubber hose
rubber materials
Due to the number of interacting forces, it is STRONGLY RECOMMENDED THAT YOUR ELASTOMER SELECTION BE RIGOROUSLY TESTED IN THE ACTUAL APPLICATION, performance assumptions must be checked so that you are certain that all variables have been carefully considered
In crush seal applications the o-ring is squeezed at an angle relative to its cross section. In these applications the o-ring is completely confined and pressure deformed within a 45ยบ triangular gland, as depicted. The table below lists recommended dimensions for static crush seal glands by AS-568A o-ring dash numbers. For more information please contact one of our project managers at1.800.227.3539 ext.19
Static Crush O-Ring Gland Design
Static Crush Oring Seal Design
Dynamic Radial Seal Design
 
Static Radial Seal Design
 
Dynamic Reciprocating Seal Design
 
Static Axial Seal Design
 
Static Axial Seal Design
 
Dynamic Rotary Seal Design
 
Static Crush Seal Design
 
Dovetail Seal Design
Custom Molded Rubber
AS568 -004 through -475 Static Crush Seal Design Guidelines
AS
-568
DASH
#		 Nominal
Cross
Section

 O-Ring Cross Section Gt / Ht R Radius R1 Max Radius
In. +/- In In. In.
-004 to
-050		 1/16 0.070 0.003 0.092 / 0.095 0.005 / 0.010 0.020
-102 to
-178		 3/32 0.103 0.003 0.134 / 0.137 0.005 / 0.010 0.025
-201to
-284		 1/8 0.139 0.004 0.182 / 0.185 0.005 / 0.010 0.030
-309to
-395		 3/16 0.210 0.005 0.269 / 0.273 0.005 / 0.015 0.040
-425 to
-475		 1/4 0.275 0.006 0.356 / 0.360 0.005 / 0.015 0.050